lathe, is there a market?

DECO CUE

DECO CUE

AzB Silver Member
Silver Member
I wanted to know if there was anyone out there looking for a shaft/butt machine made from metal lathe like to the one pictured here ready to go.Set up with taper bars for shafts and butts and kress router mount and dust box.I have located a lathe to purchase and will be getting taper bars done soon.
What would you pay and is someone willing to pickup at my location ( Indiana)?.
IMG_3602.jpg

IMG_2992.jpg

IMG_3298.jpg
 
DATUM CUE said:
I wanted to know if there was anyone out there looking for a shaft/butt machine made from metal lathe like to the one pictured here ready to go.Set up with taper bars for shafts and butts and kress router mount and dust box.I have located a lathe to purchase and will be getting taper bars done soon.
What would you pay and is someone willing to pickup at my location ( Indiana)?.
Click to expand...

Is it 3 phase? Where about in Indiana?

Thanks,

Jason.
 
You would have to pickup lathe complete in Markleville,In 46056.The one I found is single phase 115v.
 
I'd definitely prefer 3 phase...just don't have it at the house...beaucoup bucks. Luckily, I work industrial maintenance and have access to the goodies there. But if I can find some good equipment for the house...all the better!

Datum, do you know what you'd like to get for the lathe?
 
Naked Cues said:
I'd definitely prefer 3 phase...just don't have it at the house...beaucoup bucks. Luckily, I work industrial maintenance and have access to the goodies there. But if I can find some good equipment for the house...all the better!

Datum, do you know what you'd like to get for the lathe?
Click to expand...

1 phase to 3= about 2-300 bucks, plus a bit of time wiring=softer starts, less vibration, DC breaking, programmable ramping speeds...ect...ect...
 
You must log in or register to reply here.
Back
Top