Leonard Bludworth cue

[billy-ks]

I just purchased an older (25 years). I want to make a CF shaft for it but I believe he used a 3/8 11.5 tap ( correct me if I'm wrong please) I'd like to find someone that could make me a phenolic insert with a 1" OD. Anyone capable out there?

 

[Rodney]

I forgot what the thread pitch is but it’s not 11.5. If you search the forum you’ll find the correct thread size.

 

[Michael Webb]

I just purchased an older (25 years). I want to make a CF shaft for it but I believe he used a 3/8 11.5 tap ( correct me if I'm wrong please) I'd like to find someone that could make me a phenolic insert with a 1" OD. Anyone capable out there?

Why a 1" o.d?.
It's an undersized 3/8x11.5

 

[billy-ks]

Why a 1" o.d?.
It's an undersized 3/8x11.5

Because as long as I have the insert threaded, I can cut the od to fit the carbon fiber shaft

 

[Michael Webb]

Because as long as I have the insert threaded, I can cut the od to fit the carbon fiber shaft

Threaded o.d. 1/2x13 or 9/16" is great you don't need to mess with the entire plug in the end of the shaft.
But ok,
Donald is on FB
Good luck

 

[Rodney]

I just went back and read some of Bluds old posts, I miss seeing him post! I met him in Vegas somewhere around 98,99. Was nice enough in person and had a personality as big as Texas!!!

 

[Michael Webb]

I just went back and read some of Bluds old posts, I miss seeing him post! I met him in Vegas somewhere around 98,99. Was nice enough in person and had a personality as big as Texas!!!

ATCM sections birth, was the combined effort of Leonard Bludworth, and Mike Howerton!

 

[ViliusTykun]

My understanding the pin is .348x11.45. I'd love to get a carbon fiber shaft for mine. Just today I did buy the male and female driver for it in hopes I could find a cue maker that would make the shaft for me. Atlas Supplies advertises the lathe driver pin as a Bludworth so hoping it would match up as expected.