Looking to have a shaft made

PDX

AzB Silver Member
Silver Member
I know that there are some great cue builders that frequent this site. I was wondering if someone would recomend or get ahold of me in order to have a shaft made. I have an old Tru Balance that I want to have made for my Runde. Just looking to have matching rings and pilot. Anything helps.

Patrick
 
PDX said:
I know that there are some great cue builders that frequent this site. I was wondering if someone would recomend or get ahold of me in order to have a shaft made. I have an old Tru Balance that I want to have made for my Runde. Just looking to have matching rings and pilot. Anything helps.

Patrick
www.erwincues.com Great work and only 90.00 for a shaft.
Check him out.
 
PDX said:
I know that there are some great cue builders that frequent this site. I was wondering if someone would recomend or get ahold of me in order to have a shaft made. I have an old Tru Balance that I want to have made for my Runde. Just looking to have matching rings and pilot. Anything helps.

Patrick

Patrick,

You have a couple cue makers in your area who can make you a nice shaft.

You can find either of them in the "On the Wire" pool papers found in almost every bar or pool room in the portland OR area.

"Shark shooter billiards" Greg Sowder. Greg is the most experienced in the area. Does a great job.
and
"Craig's Tips and more" Craig Irwin - Craig is new, but does a great job as well.

Either one will do a excellent job.
 
Back
Top