Manual Inlay patterns ?

RRfireblade

Grammer Are For Stupids
Silver Member
Not sure about this but I figured I'd throw up a quick post.

I have and can make inlay patterns for manual inlay machines , ie. Pantographs. Is there any cue builders out there , not yet gone CNC (or that refuse too ;) ) , that would be interested in custom inlay patterns of thier design , reasonably priced ?

Jay.
 
RRfireblade said:
Not sure about this but I figured I'd throw up a quick post.

I have and can make inlay patterns for manual inlay machines , ie. Pantographs. Is there any cue builders out there , not yet gone CNC (or that refuse too ;) ) , that would be interested in custom inlay patterns of thier design , reasonably priced ?

Jay.
Can you make 4 to1 ratio patterns? And what is the cost?
 
I can do any ratio I'm sure. Most of what I have done so far has been 2/1 tho. The only issue is that they may have to be pockets on one sheet and part cutout on another. In that ratio as the CNC I have at home only has a small 5x10 table , I build jewelry peices on it. Really big stuff I would have to do at the my shop , probably after hours , which would impact cost.

I'm still figuring out pricing , as a ballpark I would have to guess smaller basic sizes might start at $50 +/- , step to $100+/- and run to $150 depending on material used.

Open to thoughts tho.

Added this :

I'm still working on pricing but it would be based on size and complexity of design , as I have to write the cad/cam which is most of the time involved.
 
Last edited:
WEll I would supply all of the material to be used for my patterns. Which it is a soft material ( DELRIN) I know it machines real easy. Where are you located?
 
Love Delrin , use it for alot of things (acetal resin).

I'm in Central Florida , just outside of Orlando.
 
Back
Top