NEED A CUE MAKER!!

[HelpMeScrubs0013]

I have a partial shaft Z3 that I need threaded for a 3/8x10 modified pin. Just plain black collar.

 

[Beebop21]

Danny Joe Hassel (Kearney Cue Collective on facebook) recently finished a predator partial for me in this pin, and did a good job. Stand up guy to deal with.

Sent from my SM-N986U using Tapatalk

 

[HelpMeScrubs0013]

How long it take?

 

[Beebop21]

I'm not sure what his turnaround time would be for just the shaft, the one he did for me was matched to a custom butt, so part of a larger project. Pretty sure the turnaround time would be very reasonable though.

I'm also sure there are a lot of other cue makers who could do the work for you in short order, that others will throw out, maybe one will be close to you.

Sent from my SM-N986U using Tapatalk

 

[j2pac]

I have a partial shaft Z3 that I need threaded for a 3/8x10 modified pin. Just plain black collar.

Contact Bob Dzuricky @
www.dzcues.com
IF he isn't busy, he might do it up. Pristine work, and one of the straightest arrows on the planet, IMO.

 

[$TAKE HOR$E]

Where are you located, there might be someone within a reasonable distance to save on shipping time.

 

[HelpMeScrubs0013]

I'm in north Texas. Cue maker near me to busy.

 

[HelpMeScrubs0013]

Contact Bob Dzuricky @
www.dzcues.com
IF he isn't busy, he might do it up. Pristine work, and one of the straightest arrows on the planet, IMO.

Thank you! I contacted him it's on his way. Hope he does a good job.

 

[Coos Cues]

Thank you! I contacted him it's on his way. Hope he does a good job.

There is zero chance he won't do a good job. Zero.

 

[j2pac]

There is zero chance he won't do a good job. Zero.

 

[Poolhalljunkie]

I'm in north Texas. Cue maker near me to busy

Robertson Custom Cues in Abilene, or Jerry Powers Jerico Cues. Both are located in Abilene TX

 

[j2pac]

Thank you! I contacted him it's on his way. Hope he does a good job.

You're welcome.
Trust me, I am certain that you are in good hands.