Need Some Advice

M

mzbhavnhrl

AzB Silver Member
Silver Member
I Did a trade with cfrandy for a palmer titlelist and i like the cue alot butt both shafts are warped bad and befor i did the trade with him he said the one had a little taper roll and the other was strait. well the one ivory ferrul shaft has is warped and rolls out about a 1/8 or better and the other roll out like a 1/2 inch and doesnt even match up with the joint either. The diameter of the joint is .850 and the diameter of the one shaft is .830. He seems like a good person and all but i dont no what to do about this problem. I have tried to get ahold of him all afternoon and havnt heard anything back yet. Do does anyone have any advice??

Thanks Brian
 
Need some advice

I am but what could be done to make this right? ask Him to pay for 2 new shafts or what?

Thanks
Brian
 
Give him Time...

Sir, Randy is a straight up guy and unfortunately he currently has a-lot on his plate. I'm sure he will make thing right by you. Give him a couple of days though...
Dan Z
 
mzbhavnhrl said:
I am but what could be done to make this right? ask Him to pay for 2 new shafts or what?

Thanks
Brian
Click to expand...

Basically, just undo the deal, unless he wants to pay for two new shafts.

He seems to be a straight-up guy. Hopefully, this will all be resolved shortly.

Joe
 
Focus your energy and conversations with him.. not us.

You choices are obvious.

1. Undo the deal.

2. Work out a compromise if possible.

Just be patient and keep a cool head...

Good luck!!
 
You must log in or register to reply here.
Back
Top