New CNC tapering complete turn key set-up

tsp&b

tsp&b

Well-known member
Silver Member
New CNC tapering complete turn key set-up
I have made more available.... A complete stand alone turn key setup! You get it all!!
Includes the following:
CNC Carriage & cross slide assembly with 2 stepper motors, wiring & connectors
48-inch Bed & rack assembly and Baseboard
Standard 15 mm through bore Headstock with 3 jaw chuck & 24 position indexing.
½ HP, DC motor, motor mount & Belt
#150 M, Modified Tailstock with ½ drill chuck & handle extension.
Spur driver
60-degree dead center
Router Mount
Bosch Colt variable speed trim router model PR20EVS with modified Base.
2 – Router bits
Gecko 540 Driver box w/ power cable & parallel cable
Fully refurbished Dell computer w/ MS XP operating system, Monitor, Key Board and Mouse.
Intro version of Mach 3 with tapering set-up file installed and ready to go.
G-code files for a shaft and a butt taper. Plus, one set of custom taper g-code to your specifications.
All NEW (except the reconditioned computer).
Price = $2995.00 + S&H.
Call 217-320-2404
Or Email: midamericapool@yahoo.com
CNC w Bosch router.jpg
 
Todd, I was the owner of your first one, worked fantastic.

I feel a video is needed to show how it works. When it starts going keep a close watch of the two stepper motors you will see on turning at a good spin moving the cutter down the rail, if you watch the other spindle you will see it moving very slow moving the router inward for tapering depending on drawing G code and macro calls you put in.

https://www.youtube.com/watch?v=9-RhG_rxAXk
 
You must log in or register to reply here.
Back
Top