Painting trim on GC3

[rykr01]

Any good ideas on painting the metal Brunswich logo plate or painting the bottom of t he logo on the metal trim around the ball racks? I had the metal trim chromed and was thinking about sticking contact paper over the logo, cutting it out with a sharp xacto knife, and then spray painting the bottom.

But I'm thinking the metal Brunswich logo in the rail might have to be hand painted.

 

[WobblyStroke]

ask the guy with the 9foot gold crown for sale thread. the work done on his is incredible.

 

[rexus31]

Any good ideas on painting the metal Brunswich logo plate or painting the bottom of t he logo on the metal trim around the ball racks? I had the metal trim chromed and was thinking about sticking contact paper over the logo, cutting it out with a sharp xacto knife, and then spray painting the bottom.

But I'm thinking the metal Brunswich logo in the rail might have to be hand painted.

I spray painted mine and removed the paint from the Brunswick logo with Q Tips and laquer thinner.

 

[rexus31]

ask the guy with the 9foot gold crown for sale thread. the work done on his is incredible.

Namelate isn't painted on that table.

 

[WobblyStroke]

Namelate isn't painted on that table.

i see. either way, if you get yours looking even half as good as his, it'll be a beaut. GL

 

[Hungarian]

ask the guy with the 9foot gold crown for sale thread. the work done on his is incredible.

A link would be nice.

 

[Island Drive]

Cornblast the wooden areas. Sand light/stain then seal with clearcoat.