Phenolic inserts for shaft

Snooker Theory

AzB Silver Member
Silver Member
Hmmm.... will have to dig deeper. Initial searches just showed rod from flat lam material, which was the reason i "rolled" my own, so to speak - ripped some sheet and turned short sections of rod on the lathe.

This is close to what i need for furniture project, if i step up from #10 bolt, to 1/4" bolt

https://www.usplastic.com/catalog/item.aspx?itemid=35434&catid=

For cues i use 3/8"-10 joint, so this is what i was planning to keep on hand.
More or less "just-in-case" because so far wood without insert works ok. I saturate with super glue, and then wax. But i see a lot of you guys use inserts and it's a good idea.

https://www.usplastic.com/catalog/item.aspx?itemid=35439&catid=

Thanks for the advice and info!
smt

Edited - OK. More search, found Atlas billiard sells the rolled rod. Thanks!

..................
 
Back
Top