That Asian curl is 1 BA looking cue sir. Thanks again for sharing. Make sure you post up when your finished with the Afzielia forearm. Thanks again for posting these.
My pleasure. Thank you Sir
That Asian curl is 1 BA looking cue sir. Thanks again for sharing. Make sure you post up when your finished with the Afzielia forearm. Thanks again for posting these.
For those who love Zircote, Mcdermott made a similar cue called EF2 that can be had for reasonably low prices when availableThis is a Zircote merry widow from Chris Nitti. It is hard to fully capture the grain but this photo is the best I've taken.
Sent from my BLN-L24 using Tapatalk
Mine is available at a reasonably low price too. LOLFor those who love Zircote, Mcdermott made a similar cue called EF2 that can be had for reasonably low prices when available
Sent from my SM-A600U using Tapatalk
Would you mind of I piggyback off this, and post a picture of some wood I have, but can't ID? ...If so, let me know and I'll delete it.
I've had 3 or 4 people look at this wood, and they're unable to ID it. Most likely it's an exotic rain forest hardwood of some sort. It's very dense, hard, and heavy. It's been sitting in my garage for +/- 15 years.
I have 3 boards, roughly 36" long x 4" wide x 1-1/18 thick.
I would like to have a cue made. I probably have enough for a couple cues. The only problem is it's thickness. Not thick enough for a butt, however maybe with veneers?
Here's a picture. "Unfinished" on top. "Finished" with a coat of polyurethane below. The picture doesn't do it justice. It's absolutely beautiful in person.
Would you mind of I piggyback off this, and post a picture of some wood I have, but can't ID? ...If so, let me know and I'll delete it.
I've had 3 or 4 people look at this wood, and they're unable to ID it. Most likely it's an exotic rain forest hardwood of some sort. It's very dense, hard, and heavy. It's been sitting in my garage for +/- 15 years.
I have 3 boards, roughly 36" long x 4" wide x 1-1/18 thick.
I would like to have a cue made. I probably have enough for a couple cues. The only problem is it's thickness. Not thick enough for a butt, however maybe with veneers?
Here's a picture. "Unfinished" on top. "Finished" with a coat of polyurethane below. The picture doesn't do it justice. It's absolutely beautiful in person.
Most likely can't be identified without a clear picture of the endgrain and a good close picture of the board. If anyone on this board can identify it would be Mr. Crisp, that dude is a wood junkie of epic proportions. You can post in the ask a cue maker section for the best response.
For points, it's plenty. For Forearm, can use 1 1/4" squared. Butt bottom 1 1/2" squared. Laminate it. Just an idea.