Pocket Reduction on a Olhausen GC 3

Ih82luz

AzB Silver Member
Silver Member
I'm looking to have my pockets reduced to BCA tournament standards on my table. The mechanic is using the Accu fast rail, and will cut to size the rubber.

Any concerns I should have on the end product?
 

Poolhalljunkie

AzB Silver Member
Silver Member
Who is doing the work?

I'm looking to have my pockets reduced to BCA tournament standards on my table. The mechanic is using the Accu fast rail, and will cut to size the rubber.

Any concerns I should have on the end product?


What is an Olhausen GC 3? And who is doing the work?
 

JoeyInCali

AzB Silver Member
Silver Member
Olh Grand Championship 3 ?
I've played on one black Olh Championship table .
The rails are pretty low and the corner pockets rattle balls .
You will need a good mech to fix those corners.
 

fastone371

Certifiable
Silver Member
Its not just a matter of cutting the rubber to length but you also need to extend the sub-rail with wood. If you mechanic is good he should be able to correct the pocket angles to eliminate some of the Olhausen Death Rattle too while he is at it.
 
Top