Predator 4K-3 F/S!

Hunter

The King of Memes
Silver Member
Hi all,

I just picked this cue up in a trade deal. It's a Predator 4K-3 with both a 314 shaft (with cat) and a Z-2 shaft. The cue weighs just a hair over 19 oz. with one shaft and 18.8 with the other. The 314 shaft is 12.75mm, and the Z is 11.80 mm. The Z shaft has a medium Kamui tip and the 314 has a Moori medium.

The cue is in good, played shape. There aren't any noticeable dings even though I'm sure if you looked hard enough you might find a little one or two. The ring above the buttcap has a little finish blem that looks like the ring might have lifted a little bit. There is also one small area on the finish close to the next ring, but it's very small. Might have been a little finish bubble. I rolled the cue on a table yesterday and on one table, the butt rolled with just a bit of light under it, but the cue seemed to roll straight on the rail. I also rolled it on the next table and it seemed good. The Z shaft rolls straight and the 314 looks to have a little rollout in the middle, but the tip and joint stay on the table. The cue plays well with both shafts and the little rollout doesn't affect the play at all, just makes for an affordable playing cue.

Asking SOLD!!! shipped in the CONUS or will consider trades.

Thanks for looking!

Steve
 

Attachments

  • Copy of Predator 002.JPG
    Copy of Predator 002.JPG
    34.7 KB · Views: 305
Last edited:
Ebony floating points...
 

Attachments

  • Copy of Predator 003.JPG
    Copy of Predator 003.JPG
    95.8 KB · Views: 291
Back
Top