Hello all,
I am looking to purchase a used table early to mid January. Assuming the table I have in mind is in good condition and I end up purchasing it, I would need it moved 290 - 300 miles then setup/installed. So a few questions...
1. What should I look/check for when inspecting the table? Its a fully assembled used 9' Diamond, if that makes a difference.
2. What should I expect to pay in moving/installation charges?
3. The table will be going in a non-climate controlled garage. I'm aware that constant ups/downs of temperature can lead to warping, but I only see this being an issue during seasonal changes, and minimal at that. Is this something I should be concerned about?
Thank you all in advance for responses.
I am looking to purchase a used table early to mid January. Assuming the table I have in mind is in good condition and I end up purchasing it, I would need it moved 290 - 300 miles then setup/installed. So a few questions...
1. What should I look/check for when inspecting the table? Its a fully assembled used 9' Diamond, if that makes a difference.
2. What should I expect to pay in moving/installation charges?
3. The table will be going in a non-climate controlled garage. I'm aware that constant ups/downs of temperature can lead to warping, but I only see this being an issue during seasonal changes, and minimal at that. Is this something I should be concerned about?
Thank you all in advance for responses.