Quote needed if any interest.

[Onepocketking1]

Hello AZB Cue Makers. I just acquired an old Dufferin sneaky pete that I would like some work done on it. The butt is beefy so you have plenty to work with. Here is a list of the things I would like done.

1. Bring the joint down to .840". And add a black joint collar.
2. Give the butt a slim taper. Add a black butt collar.
3. Tap the butt for a bumper for my extension. I'll send you the bumper.
4. I need the butt to weigh 15oz.
5. Just seal it. No clear coat.

PM with your quote.

Thanks

 

[tg_vegas]

The challenge on that one might be saving the Dufferin logo if it can't come out pre-taper.

How much does the butt weigh in its current state?

 

[Canadian cue]

How close are the points? A good maker can even them out for you, and unless you are taking a huge amount off the butt the logo will be fine.

 

[jazznpool]

How close are the points? A good maker can even them out for you, and unless you are taking a huge amount off the butt the logo will be fine.

Points already badly staircased are not going to get straigtened.