removing weight bolt in schon

stevekur1 said:
Good luck getting the screw out!

I Have contacted shon on this matter, and they said that they glue them in. Stupid if you ask me! They said they need the cue to get the screw out.

Mike Webb told me that if you get the screw out, you can you a plastic screw. the one that is used to hold a toilet seat on the bowl, the only thing is that you will have to have the end tapped for the screw that hold on the bumper.

I Tried everything i could to get the screw out, and was affraid of snapping upart the wood at the bottom of the cue above the cap.

I Thought maybe accidentaly the were glued in when they put the screw in the glue wasnt dry on the butt cao, but apparently i was wrong

Good Luck Again
Steve
Click to expand...

I've seen a few Schons where the butt was broken from trying to remove an epoxied weight bolt.

Here's some advice on removing weight from a cue: have it done professionally.

Chris
 
If it is glued in Take the rubber bumper out an take a small sodering iron stick it in the rubber bumper hole carefuly for about 1or 2 min. try again
 
You must log in or register to reply here.
Back
Top