Results of the New Viking Cue Clearcoat using Meguiar's polish !!!

[WheatCues]

Pics of my automotive urethane finish using 3M's finess-it II

I know you guys are sick of seeing this cue by now, but it's the only ebony one I had finished to use....

This is my clearcoats using ONLY finess-it II polish to buff out at high-speed after wetsanding by hand with 1500g paper....

I personally think my finishes are more than adequate !

Feedback is welcomed !!!!



- Eddie Wheat

 

[conetip]

Oh and by the way, I do not use a buffing wheel just a paper towel and a soft cloth, and I know no other way, I am just a self taught Hack. I learned to finish a cue just like I learned to make cues by trial and error.!!!!!!

It is surprising how abrasive a paper towel can be. When polishing optical dies before they get hardened and get the real polish, paper towels can put micro scratches on the surface. We used felt pads in seperate containers for their grit size. Contamination was an issue to avoid. But it is hard to beat elbow grease.
All the cues look to be very good from the pictures shown .
1st impressions last a long time.
Some people like shiny and others like a matt finish.
Neil

 

[RocketQ]

grit

i wish they had grit listed on all these products
i use finesse it
i wonder if the meguirs fine cut would be more or less grit than finesse ???? to use in between my med cut & finesse

Brent I have used both. Polish with maguires then finess-it. Finesse-it is a great product and I have yet to find anything that polishes finer scratches.
Manwon nice finish keep it up.

 

[cuemaker03]

Nice cue!!!!