Sanding a predator shaft

adam boyd said:
I was told it had a finish on it and would warp if sanded. Is there any truth to this? Thanks, Adam
Click to expand...

I don't know about it warping but Predator does not warrant the ferrule if it is sanded below 12.50 or so I have been told..
JoeyA
 
adam boyd said:
Thanks, I want my shaft a bit bigger than the z shaft. Like 12.25 or 12 mm.
Click to expand...

The end of the shaft & ferrule are so hollow that its a very thin wall when new. Sanding it...especially down to 12mm and you are running a huge risk of ruining it. If you want it thin then just buy the Z. If I showed you some 314 ferrules I've removed & you saw how thin they are...you wouldn't dare sand it one bit.:wink:
 
Varney Cues said:
The end of the shaft & ferrule are so hollow that its a very thin wall when new. Sanding it...especially down to 12mm and you are running a huge risk of ruining it. If you want it thin then just buy the Z. If I showed you some 314 ferrules I've removed & you saw how thin they are...you wouldn't dare sand it one bit.:wink:
Click to expand...

thanks for the info I wont anymore lol.
 
You must log in or register to reply here.
Back
Top