Schon

[dpaulnot]

Does Schon use a same standard diameter at the joint of there cues?
If so I would like to know what that is. Thanks for help... David

 

[Duane Remick]

Does Schon use a same standard diameter at the joint of there cues?
If so I would like to know what that is. Thanks for help... David

Probably YES....
" As their shafts are meant to interchange from cue to cue "
Best to call them,
I have called them a few times over the years,
" Always been friendly, helpful

 

[Michael Webb]

Does Schon use a same standard diameter at the joint of there cues?
If so I would like to know what that is. Thanks for help... David

Hi David
Yes they're the same. .838 will get you there. But....measure the o.d. of the joint screw. The one's I have seen are .302x14. Some don't care but I do.

 

[Shooter08]

If i recall correctly .840.

 

[KJ Cues]

The older Schon steel jnts were .835" but gradually moved to the .838" range.
A lot of the shafts sent by Schon to Seyberts have been running .840",
some a little above. I shoot for .838" when building a shaft for a Schon.
.001-.002" difference per side is hardly noticeable. Most can't tell.

 

[Kim Bye]

I can`t say I have a huge database to pick from when it comes to Schon, but I tend to take measurements when I repair a cue and the Schon`s I have done work on, have all been .840"

 

[Shooter08]

They are .840, I believe Runde Custom Cues are .832.

 

[cueman]

Most I have measured were .840"