Servo Techno Isel to Mach 3?

[dunkelcustomcue]

I just picked up an older Techno Isel with Servos that is 10 plus years old. The computer was not functioning and I don't feel like spending 2k only to work in DOS. Is it possible to retrofit the system to Mach 3? Aside from changing all the Servos and controllers do I have any other options to modernize?

 

[LGSM3]

Steve

I think the older systems use Galil, "youll probably have to open the controller to see if the board inside says Galil" which if it does then you should be able to interface mach with a little studying and a Mach plug in

 

[dunkelcustomcue]

http://i1132.photobucket.com/albums/m561/Steve_Dunkel013/6d64ebafa81f6158944352003176fa4d.jpg

Couldn't find any manufacturer markings on it.


Sent from my iPad using Tapatalk HD

 

[cutter]

Servo

Steve,
I have the LC controller on mine. Does yours have a pci or isa board
in the non functioning computer. If so you should be able to pick up
a cheap replacement computer on fleabay. The techno software isn't as
multi functional a mach3, but it works fine.