Servo Techno Isel to Mach 3?

dunkelcustomcue

dunkelcustomcue

AzB Silver Member
Silver Member
I just picked up an older Techno Isel with Servos that is 10 plus years old. The computer was not functioning and I don't feel like spending 2k only to work in DOS. Is it possible to retrofit the system to Mach 3? Aside from changing all the Servos and controllers do I have any other options to modernize?
 
Steve

I think the older systems use Galil, "youll probably have to open the controller to see if the board inside says Galil" which if it does then you should be able to interface mach with a little studying and a Mach plug in
 

Attachments

  • ImageUploadedByTapatalkHD1411329976.082584.jpg
    ImageUploadedByTapatalkHD1411329976.082584.jpg
    92.4 KB · Views: 366
  • ImageUploadedByTapatalkHD1411330050.000081.jpg
    ImageUploadedByTapatalkHD1411330050.000081.jpg
    91.5 KB · Views: 382
Servo

Steve,
I have the LC controller on mine. Does yours have a pci or isa board
in the non functioning computer. If so you should be able to pick up
a cheap replacement computer on fleabay. The techno software isn't as
multi functional a mach3, but it works fine.
 
You must log in or register to reply here.
Back
Top