Table rolls away from rails

S

shag_fu

AzB Silver Member
Silver Member
Had my anniversary recovered with new rails in April. 860hr felt. Pocket speed shots near the rail all tend roll away from the rail as they slow down, about 3/4” over the last 12”. A few inches away from the rails it’s not an issue. What are things I need to look at to address this?


Sent from my iPhone using Tapatalk
 
Could be the way the cloth is pulled as well. I recovered my table and have that issue. Pulled too tight in the middle at the end rail and didn't have enough to pull over and down by the pockets. Going to redo it even though it rarely causes a miss.
 
shag_fu said:
Had my anniversary recovered with new rails in April. 860hr felt. Pocket speed shots near the rail all tend roll away from the rail as they slow down, about 3/4” over the last 12”. A few inches away from the rails it’s not an issue. What are things I need to look at to address this?


Sent from my iPhone using Tapatalk
Click to expand...
What's causing the balls to roll away from the rails but roll straight when not to close to the rails, is the spray glue build up. Balls rolling on the spray glue roll away from the rails, once they're no longer on the spray glue, they roll straight.
 
You must log in or register to reply here.
Back
Top