For tip repair I have used a Willard tipper. I have a cue with an ivory ferrule, but without a tip pad.
I am hesitant to use the Willard's abrasive disk to get down to the bare ferrule to install the tip pad, I'm afraid the relatively coarse abrasive could cause the edge of the ferrule to chip.
Any suggestions, and also where is a good place to get the tip pads?
Thanks
I am hesitant to use the Willard's abrasive disk to get down to the bare ferrule to install the tip pad, I'm afraid the relatively coarse abrasive could cause the edge of the ferrule to chip.
Any suggestions, and also where is a good place to get the tip pads?
Thanks