UniLock Butt Only 80.00 Shipped.

Cuemaster98

AzB Gold Member
Gold Member
Silver Member
Unilock fullsplice butt only $80 shipped (Joint is .80") oil finished.
157819765_o.jpg

157819773_o.jpg
 
Last edited:
Jay, I just open up the other link into an image to show the points. Again this is for butt of the cue only (No shaft). Collar is 0.80 as well...great if you have a z shaft.

Regards,
Duc.
 
has anyone on this forum used one of cuemaster98's full splice blanks? and in your ebay listing it says your blanks have had a previous logo sanded off.....just wondering because these look kinda like predator sp butts. Just curious.
 
These blanks are made by Falcon and they are not Predator SP butts :). We sold hundreds of these near finish blanks, we have about 30 plus left if anyone is interested in them. All the blank has a pre-tap 5/16-18 thread comes with and without stainless steel collar. Great value for conversion and great for someone who want to make their own first cue. Just need a shaft and pin with a little help from a cue repair shop or cue maker.

Regards,
Duc.

mtdsports said:
has anyone on this forum used one of cuemaster98's full splice blanks? and in your ebay listing it says your blanks have had a previous logo sanded off.....just wondering because these look kinda like predator sp butts. Just curious.
 
JayBaltimore said:
who's the maker of this cue butt?

That would be me, I added the faux ivory joint and the unilock pin. Originally built this butt to be used with a z-shaft for snooker but end up selling just the z shaft. So the butt is now available for same...the butt roll and sight straight. It's was my second unilock pin install...those unilock pin are expensive. The taper at the joint is a little small at only .80 inch.

Regards,
Duc.
 
Cuemaster98 said:
That would be me, I added the faux ivory joint and the unilock pin. Originally built this butt to be used with a z-shaft for snooker but end up selling just the z shaft. So the butt is now available for same...the butt roll and sight straight. It's was my second unilock pin install...those unilock pin are expensive. The taper at the joint is a little small at only .80 inch.

Regards,
Duc.

would you trade a case 1x2 for that butt.???
 
Last edited:
Yup...it play great thought! Really meant for a snooker shaft but still very strong for pool.

Regards,
Duc.

BHW said:
Definately looks like it tapers dramatically at the joint end.
 
I can do one with 3/8-10 warpless with no joint collar using the same blank. I have about 15 near finish blank that just need the pin. Or I can do one with 3/8-10 with stainless steel collar and a leather wrap for $150 butt only. Collar on both will be at .84.

Regards,
Duc.

sponge bob said:
Would you be able to make one with a 3/8x10 pin for about the same price?

Asgar
 
Back
Top