veneer fixture from lee mounted and balances.

dave sutton

dave sutton

Banned
next i need to set up the vaccum for the push plate and were in buisness. hope its everything i hope it will be. seemless miters. dreamy

heres my mounting porcedure as per lee

tools needed

4 allen head screws 1/4x 20tpi x 3/4' in legnth
1/4 x 20 tap.
3/16 drillbit
1/4 drillbit
3/8 drillbit for countersinking head

drill
allen key

thats it.

marked out all my holes on the jig drilled them 1/4 thru then half at 3/8 to burry the head. put back on saw put the blade in. raised it up high to go into the channel of the jig. took my fence up to the edge to square it up. center punched the tabletop. took jig off. drilled 3/16 thru then tapped for screw put jig back on and torqued down. done...

heres some pics. easy. it would have taken me 20 mins if my drill didnt die...lol

hope this helps anyone needing to mount this jig

012.jpg

002.jpg

001.jpg

006.jpg
 
Awesome! I have one of the originals Lee built and works great. I am very happy with my set up. Mounted the same of coarse. Fast and very accurate.
It is the wild saw blade that does such a great job. Well worth the cost IMO.
Have fun with it!
 
You must log in or register to reply here.
Back
Top