veneer rings

I actually love the overall design "cartesian" of the cue monster with the open face in lieu of the typical cue building router style with the clunky uprights that are almost always in the way. Have built 2 machines very similar to cuemonster and 2 more are in the works. I agree that 1.4" would kinda suck.

I looked at a few pictures of cue monsters online and think it would be really simple to retrofit one.

http://www.ebay.com/itm/LINEAR-STAG...ultDomain_0&hash=item3cad5326e9#ht_2266wt_867

these people make a really low profile stage with kerk screws. The overall height is 1.5" and the existing motors would be a direct bolt on. They also have them in longer travels.
 
LGSM3 said:
I actually love the overall design "cartesian" of the cue monster with the open face in lieu of the typical cue building router style with the clunky uprights that are almost always in the way. Have built 2 machines very similar to cuemonster and 2 more are in the works. I agree that 1.4" would kinda suck.



I looked at a few pictures of cue monsters online and think it would be really simple to retrofit one.



http://www.ebay.com/itm/LINEAR-STAG...ultDomain_0&hash=item3cad5326e9#ht_2266wt_867



these people make a really low profile stage with kerk screws. The overall height is 1.5" and the existing motors would be a direct bolt on. They also have them in longer travels.
Click to expand...


Jake, I have used a few of these actuators. They are built nice however I don't like the way they mounted the leadscrews. I ended up replacing them with a better pitch and spring loaded them to one side for backlash issues. Still not a bad way to go though.

Jim.
 
Mc2 said:
Jake, I have used a few of these actuators. They are built nice however I don't like the way they mounted the leadscrews. I ended up replacing them with a better pitch and spring loaded them to one side for backlash issues. Still not a bad way to go though.

Jim.
Click to expand...

Yah, ive only used one for z so it wasnt critical. Wouldnt b that hard to thread one end. A 404xr would be ideal but i dont think the machine has enough room in height
 
Jake, will not matter as the original poster most likely does not have the correct equipment to perform the retrofit.

Jim.
 
You must log in or register to reply here.
Back
Top