Which profile side cushions do I have?

92GTA

92GTA

Registered
I seem to have a no-name table so I am trying to figure out what profile rubbers I have to order some new Artemis cushions.

Please take a look at the below pictures of one of my rails without the rubber and with. Also note that measured from the slate to the top of the nose of the cushion is ~ 1 5/16", maybe 1 4/16", hard to tell exactly.

Am I K66 or K55 or something else?

Thanks!
 

Attachments

  • WP_000051.jpg
    WP_000051.jpg
    48.2 KB · Views: 368
  • WP_000052.jpg
    WP_000052.jpg
    49.7 KB · Views: 364
  • WP_000053.jpg
    WP_000053.jpg
    50 KB · Views: 371
  • WP_000054.jpg
    WP_000054.jpg
    51.9 KB · Views: 377
  • WP_000055.jpg
    WP_000055.jpg
    48.8 KB · Views: 369
What is the measurement on the top of the cushion? Measure from the base of it where it glues to the rail to the tip of the cushion where the ball bounces off.
 
Or just measure the face height of the subrail where the cushion glues to it.
Typically 1 5/16" for K55 or 1 3/16" for K66

picture.php
 
Last edited:
K66 it is then, excellent.

Thank you guys for the help and confirmation so I can order the parts with confidence!

1 more thing, my rails don't have a raised cushion guide on the center of their face lengthwise that fits into the molded impression in the cushions to assure they go on perfectly straight.

Can this easily be made? What should the dimensions and faces of it be like? Will a wooden dowel with a cut face to glue to the rail work?
 
92GTA said:
...my rails don't have a raised cushion guide on the center of their face lengthwise that fits into the molded impression in the cushions to assure they go on perfectly straight. ...
Click to expand...

Subrails typically do not have a raised guide.
Concentrate on matching the top edge of the cushion with the top edge of
the subrail without stretching the cushion as it's applied.
 
You must log in or register to reply here.
Back
Top