WTB Ash Shaft w/ 3/8x10 Joint

[vacation]

Looking for an ash shaft, preferably 29" with a 3/8x10 joint. Preferably between 11 and 13mm tip.

It's a shot in the dark, but I figure I'l try...

 

[Renegade_56]

I hope you like a very stiff hard hit.

 

[vacation]

I hope you like a very stiff hard hit.

You got it! :grin-square:

Also worth noting that a conical taper would be preferred. Again, shot in the dark, but I've seen a few cues sell on here with an extra ash shaft.

Grey Ghost won't make me one. Oh well.

 

[greyghost]

You got it! :grin-square:



Also worth noting that a conical taper would be preferred. Again, shot in the dark, but I've seen a few cues sell on here with an extra ash shaft.



Grey Ghost won't make me one. Oh well.

I just won't do it till I can cut that board up lol. Maybe when I get in I'll pull that big son bish out and take a wack at it.


Sent from my iPhone using Tapatalk

 

[MikesCues048]

Contact William of Dominiak Cues @
Dominatorshaft.com
Dominator 4 is maple & ash, AKA "half ash shaft"
Dominator 5 is straight grain 8 piece radial laminated quarter sawn ash shaft 29-30" 11mm. -13.5mm. AKA "full moon" (all ash)
Tell William Michael says hello & GOD bless