WTB predator shaft for a South West Cue

[Dale Nichols]

Anybody have a predator shaft with a South West 3/8x11 joint? They just take to long to build one.

 

[Mr Hoppe]

Pete Ohman (Omen Cues) uses that pin. Maybe he already has, or can make you one to match your cue.

 

[Danktrees]

or bryan mordt

 

[Rip]

Dale,
I have one 3/8x11 for the SW pin made from the Predator 314 blank. It's 29" long, weighs 3.0 ounces and is 12.45mm at the ferrule with a new Moori M tip. It has a solid black collar, no dings, very slight lift mid shaft but definitely nothing problematic. $145 delivered within the lower 48. PM or email me at VaGent7@aol.com

Regards,
Rip

 

[Ant812]

you can have seyberts make you one. i had one made for mine and it was delivered to me in about a week.

 

[KJ Cues]

Ant,
I was the one that built your shaft and I can build one for you Dale
as well. I think I can have it done in about a week but I'm going to need at least a jpeg to match your ringwork correctly. PM me.

 

[Ant812]

Ant,
I was the one that built your shaft and I can build one for you Dale
as well. I think I can have it done in about a week but I'm going to need at least a jpeg to match your ringwork correctly. PM me.

i didnt know that was you that made it. you did a great job, much appreciated.