FS: Drill Lathe For Tips & Shaft Condtioning

bnall

<---Proud Dad
Silver Member
What I have for sale is this nice drill lathe. It will do tips, clean and recondition shafts. The frame is made from aluminum tig welded construction and its adjustable too. All you need is a 3/8 chuck drill. Adjustable rubber wheels at the tip end will not mar the shaft. These wheels are the correct size for shaft repair and hold the shaft securely. They are easily adjustable using the thumb nut. No tools needed to adjust. No collets needed. This also comes with 5 stainless steel male 3/8" LATHE DRIVE PINS (5/16-18, 5/16-14, 3/8-10, Cue Tech/ Scorpion style & Radius/Ball Screw) and 2 speed controllers (one foot pedal operated and one knob style). This has really served me well the past couple of years and the only reason I'm selling it is because I have upgraded to a regular lathe now.


SOLD



IMG_0009.jpg
 
Last edited:
Brian,

How does it do tip replacement? I don't see anything that would press the tip to the ferrule and cut the tip. Is there an attachment not shown for tip jobs? Excuse my ignorance if I'm way off, I'm just starting to get into the processes of doing my own repair and etc.

Todd
 
Last edited:
As I said, it's an older model Shaftmaster.
 
Last edited:
Brian,

How does it do tip replacement? I don't see anything that would press the tip to the ferrule and cut the tip. Is there an attachment not shown for tip jobs? Excuse my ignorance if I'm way off, I'm just starting to get into the processes of doing my own repair and etc.

Todd


No theres no attachment for pressing the tip to the ferrule. This is how I did it....I would cut the old tip off, put the shaft in the spinner, face the ferrule off with 220 sandpaper glued to a wood block, glue the tip to ferrule and trip it off with a brand new razor blade. Really works well, but you will need to practice a couple of times to get the hang of it.
 
Last edited:
There should be a hand tool included. It works like any other lathe except you hold the tool in your hand, let it rest on the aluminum bar and guide it with your hands while you do the cutting.

Much the same way woodworkers do it with a hand chisel.
 
There should be a hand tool included. It works like any other lathe except you hold the tool in your hand, let it rest on the aluminum bar and guide it with your hands while you do the cutting.

Much the same way woodworkers do it with a hand chisel.

Yes there is. I just forgot to about it. I always used a razor blade. I have about $130 invested in the drive pins and speed controlers alone.
 
Very nice looking set up. If I had alittle more room in my basement
this would be ideal. Good Luck with your sale.
 
Back
Top