Can warp be fixed??

[pulzcul]

Is it possible to turn a slight warp out of a butt..Its a wrapless solid piece old Huebler with a 1/4 in. lift at the joint. I bought it on ebay planning to refinish it but??? Thanks for any advice. Don

 

[dgem]

based from my experience, if both shaft and butt roll straight you need to get the cue refaced to make them roll straight.

 

[BLACKHEARTCUES]

Is it possible to turn a slight warp out of a butt..Its a wrapless solid piece old Huebler with a 1/4 in. lift at the joint. I bought it on ebay planning to refinish it but??? Thanks for any advice. Don

To take a 1/4" warp out of a butt, you will have to reduce the thickness by a little over a 1/2". That is a lot...JER

 

[pulzcul]

To take a 1/4" warp out of a butt, you will have to reduce the thickness by a little over a 1/2". That is a lot...JER

Yes that is alot. End up being a 13 oz. cue. Not much left. Thanks