Custom Maintenance Sets

RocketQ

RocketQ

It's Not Rocket Science
Silver Member
For those shafts you can't buy a drive for.
Cogs
Quick releases
Jackson
You name it. Most in stock.
Male thread starting at $25 and Sets starting at $45.


John
 
Hey John, Do you have 3/8-14, Mike Bender?

Thanks, Martin


RocketQ said:
For those shafts you can't buy a drive for.
Cogs
Quick releases
Jackson
You name it. Most in stock.
Male thread starting at $25 and Sets starting at $45.


John
Click to expand...
 
Does the tap from atlas work for tapping the holes? If so Yes I do. If not I will need some info on the thread and I will make them up. If you have the thread there measure it on the OD and let me know.
John
 
jazznpool said:
Hey John, Do you have 3/8-14, Mike Bender?

Thanks, Martin
Click to expand...

You might want to speak to Mike Bender directly on the specs of his pin.
It's my understanding that he makes his own.

I recently did some shafts for a Bender (3/8x14). My tap is .005" oversize (.380"). The shafts were unbelievably tight. Granted, they were going into phenolic and I'm sure that going into wood would be a little more forgiving, but I'm thinking that there's something 'special' about his pin.
Might be worth finding out.
 
As far as the shaft side goes the std 3/8-14 should work. On the butt side I would have to grind a tap or get one made. So that would take me a little time unless I could get one from Mr. Bender.

John
 
If you can picture a piece of brass with a shank of 0.625 or 0.750 with whatever thread on the male side. The female side is the same od with a tapped hole. All of these are made to your specs if it is possible IE length shank diameter. I will shoot a picture tonight and post.
Again these can be made to your specs.


John
 
.3125 minor. Let me know when the set is ready. Prefer .840. OD. Thanks, Martin


RocketQ said:
Does the tap from atlas work for tapping the holes? If so Yes I do. If not I will need some info on the thread and I will make them up. If you have the thread there measure it on the OD and let me know.
John
Click to expand...
 
Last edited:
Martin I am a little confused. You said you want an 0.840 O.D. correct. These are not a sanding mandrel. This is merely a maintenance set like what Atlas or Prather sells for spining shafts and butts these are not built the same as a carbide sanding mandrel.
Martin give me a call when you get a chance I want to make sure you get what you are looking for. My number is on my website.



John
 
Thanks John, will do.

Martin


RocketQ said:
Martin I am a little confused. You said you want an 0.840 O.D. correct. These are not a sanding mandrel. This is merely a maintenance set like what Atlas or Prather sells for spining shafts and butts these are not built the same as a carbide sanding mandrel.
Martin give me a call when you get a chance I want to make sure you get what you are looking for. My number is on my website.



John
Click to expand...
 
Good talking with you Martin. I have what I need for the Bender. I didn't get to them last night but by the time the funds get here they will be ready.

Sets for the Cog are ready.

John
 
You must log in or register to reply here.
Back
Top