FS- 1940's Titlist Conversion by Andrew Park

atthecat

atthecat

AzB Silver Member
Silver Member
Hate to sell this one. It plays!!!

I had Andrew Park convert this 40's Titlist for me. Amazing feel.
Shaft is original to the cue. Stunning in person.
Here are the specs:
Butt: 15.625 w/ large bumper.
Shaft: 3.13oz w/ 12.15mm
Tip: S Kamui Black
Ferrule: Ivorine III
Joint: Phenolic w/ 3/8x10 pin
JPs included

Extremely minor taper roll. Less than you'd imagine a 70 year old cue to have. Nothing comes off the table. Not worth mentioning really, but want everything to be known on my sales. The shaft collar is a little thinner where it meets the shaft than at the point it meets the pin. These old cues were thinner back then.
This cue draws!!! Solid hit. $sold
DSC00880.jpg

ba51a239.jpg

d5334f0c.jpg

2b0a874c.jpg

d5334f0c.jpg

38239ad6.jpg

f749d9f8.jpg
 
Last edited:
Is the roll on the butt end of the cue or on the shaft part?

Also what's the size of the butt diameter on the thickest part?
 
mrinsatiable said:
Is the roll on the butt end of the cue or on the shaft part?

Also what's the size of the butt diameter on the thickest part?
Click to expand...

I probably shouldn't have even mentioned any roll because it's SO VERY MINIMAL.
I just like to be 100% accurate.
The butt is dead straight. The shaft has a smidge of a lift in the middle.
Nothing leaves table together or apart.
Butt is 1.3" or 33mm at it's widest.
Hope that helps.
 
You must log in or register to reply here.
Back
Top