I need help finding a rubber bumper for my Helmstetter cue.

J

justinb386

Banned
Does anyone know of a rubber bumper that I can buy that will for sure fit my Helmstetter cue, or does anyone have one for sale?

I do not care if it is new, or used.

I just really need one, because I do not think that the cue hits right without the rubber bumper.

I can still play good with it, but I think that it hits different than it normally would if it were to have a rubber bumper on it (but maybe I am wrong).

I have added a picture (bad quality picture) of the butt end of the cue.

I found a website (in the link below) that sells rubber bumpers, but none of them specify that they are for a Helmstetter cue.

http://www.muellers.com/Pool-Cue-Bumpers.html?page=1

Thank you for any help.
 

Attachments

  • Picture 10.jpg
    Picture 10.jpg
    90 KB · Views: 355
Thank you very much for your help. Can anyone confirm that the Adams Balabushka rubber bumper will fit a Helmstetter? I am guessing it will because they are the same company, but do they have the same rubber bumper? I guess I will take a $5 gamble to find out. Thanks.
 
justinb386 said:
Thank you very much for your help. Can anyone confirm that the Adams Balabushka rubber bumper will fit a Helmstetter? I am guessing it will because they are the same company, but do they have the same rubber bumper? I guess I will take a $5 gamble to find out. Thanks.
Click to expand...

I suppose if you don't want to take the $5 gamble to find out for sure, Ryan from Mueller's could probably confirm. Or I'm sure another cuemaker, repair person or subject matter expert could confirm, too. I believe Ryan goes by ratcues on here. Good luck and best wishes.

~Razor
 
i think i have one

can you measure the hole.
i have 7or 8 different bumpers in stock.
PM with measurement please
the size i think is about .600 the one i think will fit it is
.625
MMike
 
I do not know how to measure in the way that you are talking about. I do not know what .600 means. I measured the hole in the butt cap to be about 2 and 2/10ths cm across, or a little over 3/4 of an inch. I am very stupid about measuring. Thanks.
 
The measurement is actually right in between 3/4 of an inch and 1 inch (28/32 of an inch, if that makes any sense). Thanks.
 
justinb386 said:
The measurement is actually right in between 3/4 of an inch and 1 inch (28/32 of an inch, if that makes any sense). Thanks.
Click to expand...

Mine measures .880 that's the hole width, the bumpers a little bit smaller mines a 97-5 model (same as the rh-5)....Hope this helps ya out.
 
You must log in or register to reply here.
Back
Top