Bludworth Table saw jig on Powermatic 66

pescadoman

pescadoman

Randy
Silver Member
I'm thinking of selling this thing. It works just fine, but takes up alot(7-8 feet) of room.
Has a 5hp 3 phase motor on it, so you'd have to work that out with a VFD or phase converter. Custom ground 90t blade.
I've got over 2k in computer, steppers, controller, and jig..
 
pescadoman said:
I'm thinking of selling this thing. It works just fine, but takes up alot(7-8 feet) of room.
Has a 5hp 3 phase motor on it, so you'd have to work that out with a VFD or phase converter. Custom ground 90t blade.
I've got over 2k in computer, steppers, controller, and jig..
Click to expand...

Damn that's a lot of saw to chip away at cue wood with. :)

JC
 
JC said:
Damn that's a lot of saw to chip away at cue wood with. :)

JC
Click to expand...

I can do 1 inch dowels to .750 cones in 30 secs or so. Only reason I can't go faster is because the driving side starts to slip.

I have a 3hp single phase Jet I'd sell with it instead. You wouldn't get the fence though.
 
pescadoman said:
I can do 1 inch dowels to .750 cones in 30 secs or so. Only reason I can't go faster is because the driving side starts to slip.

I have a 3hp single phase Jet I'd sell with it instead. You wouldn't get the fence though.
Click to expand...

Does it have the 5/8-11 ace hardware store allthread sorry imitation of a lead screw on it? The one that the threads are too sharp to touch and bends if you look at it wrong?

For ten more bucks Leonard could have use real honest to god lead screws.

JC
 
You must log in or register to reply here.
Back
Top