I bought a 9' ProAm from my local Diamond dealer. It was installed in September 2021. In January, I first noticed a part (pictured below) laying on the floor around the table perimeter. I figured it's from the table. It seems to happen sporadically and in different spots. So far I've discovered 4 in total. I texted the dealer, but have not received a reply. Just want to know if this is something to be concerned about. So, I thought I'd post it here.
Diamond Pro-Am dropping parts
- Thread starter dtomasi
- Start date
Did you crawl under the table and have a look at the underside to see whats going on?
Yes. I texted him with the photo of the parts.
Yes. Around the outside, everything looked ok. Nothing seemed out of place, but then I don't know what it should look like. The greater area underneath the table is plywood which is the ball return area as well as a storage compartment for the legs during transport.
Pocket mounting screws, not uncommon from the factory assemblers. Just hang on to them, pick up any more that fall out, set aside and wait until the table gets the cloth changed, to mount them back in place again.
Meanwhile, check your rail bolts, they're loose.
Thanks RKC! You were right about the rail bolts. I had to tighten more than half of them.
15 ft-lbs preferably for Diamonds