Which Center Drill?

K

KentCNC

New member
What is the most commonly used center drill size for cue making? I had a piece come loose when machining on a CNC and not sure if I failed to tighten the piece enough or if the center managed to blow out some.
 
I use a #00 all the way up to a #6.
Depends on what I'm drilling the center for.
I've cut 1.5 squares to round between centers with a #00 on both ends with minimal pressure and have never had problem.
I suspect you may have forgotten to snug something up.
 
You must log in or register to reply here.
Back
Top