ldmitchell's latest activity
-
ldmitchell reacted to Sheldon's post in the thread Having shaft diameter reduced - worth researching "the right shop?" with
Like.
Cutting the taper with live tooling is always going to be more accurate. The less sanding done, the better. .25mm is slightly less than... -
Update: Here they are after redoing the middle two. Close-up they appear to get progressively better. To the naked eye the bottom two...
-
Besides that, do you think the motivation when doing the lamination was lower deflection, if anything I'd think it raises it. Supposedly...
-
I had a similar question a while back about a Huebler repair I did. Never got an answer though. It looks like it could be the same wood...
-
ldmitchell replied to the thread Huebler cues wanted.PM sent also.
-
Good one!