Search results

Which one should I do, have nipple on shaft insert machined down, or ream the butt of the cue for shaft, and how much will it cost? Will either affect the hit of the cue?

I'm looking for an inexpensive, radial pin cue butt.

Wonder if she got to keep all of that money?

Did you find a cue yet?

I've never heard of him, (not that I know much about cue makers), but was he supposed to be a pretty good builder?

Yeah. Pretty "Sharp" cue :-)

Cue Thanks for posting the pictures, itzel0101

Radial Shaft Are you looking for a radial Pin shaft? If so, have you found one yet?

Have you got to play with the cue?

Hi to all. I sent a picture of a cue to itzel0101, and he's going to post it for me. I'm trying to find out what cue builder has a signature mark like the one on this cue. Thanks

Thanks Mike. I appreciate your input.

Could something like a nylon insert be feasible?

It still moves around a couple of inches, (from joint to tip, within 1/8"-3/16") just before tightening at the joint face.

From the best I can tell, it's a 3/8" 10 pin. But the 10 TPI gauge doesn't fit exactly, it does have a little bit of slop, but a 11 gauge is to small. Also it's not like the pin that McDermott uses.

I have a cue that has a lot of slop when screwing the shaft onto the butt of the cue. It does screw on tight, and flush with the butt of the cue. What do you think the reason is for that, and what would it take to correct it?

I have an earlier Aubrick Cue, and I too was wondering if the cue maker uses pure ivory in his cues.

I found the latch. Thanks

Cue cases ..................................................

Thanks Watchez.

I've seen some very good players, wet their finger and touch the table where they want the cue ball to land.