Search results

GONE…. Thanks AZB

I dont really have good baseline for these anymore. Atlas has a few I guess 110.00 shipped

Can’t find this stuff any more. I got this back in the early 90’s put it away for a time and forgot where I put it with a few moves. In any event, I nolonger make cues and have no use for it. But I know people still want the old linen if you can find it. Hurlberts was as good as it gets.

Sometimes… but not often

Oh that just made my day…lol

Its recently become my go to chalk. No fuss no mess lasts for a good game.

Its always better if you have room for a table in the house. Mine gets a lot of use.

I normally carry 2 shafts with different tips for slow and fast conditions. Other than that, just try to adapt

Never had any luck with them

I think someone is bored

I’m a bit late to the party on this one, but I only got the shaft this past month. I could definitely take this our in league play and make some noise. I did retail it with a pressed Elkmaster (Not a milkdud). The straight taper play well for me vs their long 15” taper on the SST shaft. Overall...

This is not a bad shaft at all. I like the straight (Conical) taper on it, it has a very tight hit. I replace the Everest width a pressed Elkmaster (not a milkdud) , and the ball control is good for me and my game (About a med KAmui Clear).

I‘ll find out soon, ordered a scorpion cue with it on.

Why ?????

Sold... thanks

Variety of Rings .... what you see is what you get, most never opened. 65.00 shipped COUS, Paypal gift

Lightly used Bosch router and direct drive unit (fits Taig , cueman, Mid Amercia) . Run this with an offset tail stock and you have a tapering lathe. 180.00 shipped COUS Paypal ( buyer pays fee)

So true, what I am missing is my eyesite. Every so often I see everything clearly. but a barcue butt with a good maple shaft (conversion cue) normally workes as well as anything.

I used to be plagued by that a lot.... gotten better as I have gotten wiser and less cockey on the table.

I never lost anything with UPS, but I surely had things take a log time to get there and had shafts warp from being in the hot warehouses to long.