Who makes a shaft for a 3/8x11 pin. Not talking custom cue makers. Something I can buy off the shelf.
3/8-11 pin
- Thread starter NolesFan83
- Start date
Edited: misread post.
Last edited:
I had to wait a couple of weeks but I have purchased several OB2/OB2+ shafts from Seyberts and Ozone Billiards that were 3/8 x 11. Had to wait a couple of weeks for them to be built, OB dropped shipped direct to me.
I want. How can I discuss with you outside of mr nolesfans' thread, please?
Thankies.
shaftworx@gmail.com or look up ShaftWorx on Facebook.
Here's two of them for 89 bucks with a nice cue too boot,
Or .. here's two of them for 69 bucks with a plainer cue
Either are just fine. Of course you can adjust the taper and tip as you like.
Or .. here's two of them for 69 bucks with a plainer cue
Either are just fine. Of course you can adjust the taper and tip as you like.
Nothing a little bit of sandpaper and a drill wont fix. I brought the diameter down to 12.5 and lengthened the pro taper to about 19 inches, put on a tiger emerald tip and polished the shaft smooth with 1200, whats wrong with yours?
They don't play that well. My friend has one tuned up and it plays ok. But the shafts I have just don't play that well.
Seems like a lotta work for a little savings.
How can you go wrong with Mr. Tucker (bad m-fugger)? and he is your neighbor too...
Na... its no work at all.
I have one of those drill driven lathes sold on ebay.
http://forums.azbilliards.com/showthread.php?p=4586668&highlight=mickey+mouse+lathe#post4586668
Post #5 from the above link
I use this just for my stuff, works well so long as you protect the shaft from the rollers with a length of plastic hose.
To the OP, In fact, if you want me to, I' ll do your shafts for nothing, just pm me.
Last edited:
Way ahead of you