Anniversary/Centennial Rails

Dr Foot

Dr Foot

AzB Silver Member
Silver Member
Are the rails interchangeable on the Anniversary and Centennial 9 foot tables? Any input is greatly appreciated.

Have the opportunity to purchase a beat up Centennial, and want to use the rails for my restored Anniversary which has mica rails. It has the figure 8 hardware.

Don
 
Dr Foot said:
Are the rails interchangeable on the Anniversary and Centennial 9 foot tables? Any input is greatly appreciated.

Have the opportunity to purchase a beat up Centennial, and want to use the rails for my restored Anniversary which has mica rails. It has the figure 8 hardware.

Don
Click to expand...

You might get the answer here in this main forum, but if I were you I'd put it in the Mechanics Forum on this site. Johnnyt
 
The rails should fit between the tables,,along with the side rails--you could turn your ann into a cent with the alum siderails ,, How old is the cent? are the long rails one piece or two pieces for each side of the table. If they are one long piece for each side ,,those are from the oldest cent tables...As Johnny T stated above though,,check into the mechanics site below to be absolutly sure--but I've dealt with many of these tables, and just stating from what I've gleened from a few of the tables aI've worked with.:thumbup:
 
Thanks for the replies. The Centennial long rails are 2 piece, just like the Anniversary. Just wasn't sure about the connectors. The Anniversary has the figure 8 plates, and I haven't seen the connectors in the Centennial.
 
The actual bolt holes are in logical places.
I know a Gold Crown and an Anniversary inter-mix.
...so I would bet that the Centennial will also.
 
All the older tables with the oversize slates are interchangeable.(playing surface is 50 x 100 - slates are 57' x 107').

That means Gandy, Murrey, GC (all of them), Anniversary, Centennial, AMF and probably Global too.

Just a standard 3 bolts per rail. Obviously - this has nothing to do with 'T rail' systems.
Just talking about standard rails.

I believe Diamonds have always gad a 4 bolt rail and they are NOT interchangeable. Don't know about Connelly and some of the other brands. Mostly referring to commercial tables.

Mark Griffin
 
You must log in or register to reply here.
Back
Top