F/S 6061 Aluminum RODS

DavesCueRepair

DavesCueRepair

Just Custom Creations
Silver Member
These are the rods I made to fit my Tenon Threaders & Joe Porper Tenon Threaders. Chuck it up in your drill chuck or your tool post. It will give you dead nuts alignment everytime over and over again. Thanks Dave.

Aluminum rods
$10.00 shipped

paypal info.

davescuerepair@yahoo.com


Sent from my PC36100 using Tapatalk
 

Attachments

  • uploadfromtaptalk1318335712968.jpg
    uploadfromtaptalk1318335712968.jpg
    80.6 KB · Views: 250
  • uploadfromtaptalk1318335739595.jpg
    uploadfromtaptalk1318335739595.jpg
    82.7 KB · Views: 240
My ID is .410 on my Tenon threader and the rods diameter is .409 to slide into my Tenon Threaders the other ends is 3/8 so it will fit in the taig tool post too. I can make the rods to fit the unique Tenon Threaders too. Thanks Dave

Sent from my PC36100 using Tapatalk
 
You must log in or register to reply here.
Back
Top