F.S. Spur Driver

spur drive

Hi,

I am interested. What is the shank diameters? Do you have a punch tool that matches the 2 spurs? Do you take paypal.

Thanks,

Rick Geschrey
 
scdiveteam said:
Hi,

I am interested. What is the shank diameters? Do you have a punch tool that matches the 2 spurs? Do you take paypal.

Thanks,

Rick Geschrey
Click to expand...

The small shank dia is approx. .375, the main shank is .500. don't need a punch just press the work piece in place and away you go. :smile:
 
Bump to the top. I have some ready if anyone wants one, just let me know. Thanks a Million!! Todd
 
Brian, They should go out first thing in the morning! Thanks a Million!! Todd
 
CamposCues said:
Cool, can't wait to get it. I always have to mess around with the one I have to get it spinning right. This should save me a few minutes.
Click to expand...



I have a couple of centers like you mention that I turn shafts with, and got tired of fooling with them each time that I needed to use them. What I finally did with the one I use most, was after getting it running dead nuts, I marked the center lengthwise between the jaws and the edges of 2 opposing jaws where they grip the center with a sharpie to make getting back to that position easier the next go around. It's much quicker getting It dialed in when I use it the next time.

I should mention that It is not one of the centers advertised in this post, don't want anyone getting the wrong idea, or thinking I'm talking about this one here, Mine is different, and not spring loaded.

Greg
 
You must log in or register to reply here.
Back
Top