G-10 3/8-10 pins...

The only think I don't dig about the ones at atlas, is that it's got that "chunk" in the middle. I don't like boring to fir a pin.
 
jazzn4444 said:
The only think I don't dig about the ones at atlas, is that it's got that "chunk" in the middle. I don't like boring to fir a pin.
Click to expand...

After the 5 page thread on shoulder screws, I"M NOT TOUCHING THIS ONE WITH A 10 FOOT POLE BUT I SURE WOULD LIKE TO BEAT IT WITH A BAT!
 
Michael Webb said:
After the 5 page thread on shoulder screws, I"M NOT TOUCHING THIS ONE WITH A 10 FOOT POLE BUT I SURE WOULD LIKE TO BEAT IT WITH A BAT!
Click to expand...
:D :D :D :D :D
 
Atlas also sells the raw G-10 rod (both the rolled type and the cut from sheet type) that you can cut the pin out of any way you like it. If you decide to go this route, keep in mind that G-10 dulls even the hardest cutters like crazy.
 
desert1pocket said:
Atlas also sells the raw G-10 rod (both the rolled type and the cut from sheet type) that you can cut the pin out of any way you like it. If you decide to go this route, keep in mind that G-10 dulls even the hardest cutters like crazy.
Click to expand...

I have the G-10 rod that Atlas offers, and it really does dull the blade. I just don't have any means of making my own pins right now
 
jazzn4444 said:
couldn't find it... do you know how much he's asking for them?
Click to expand...
Call him.
He makes the 3/8 7.5 with a shoulder for around 12-15 depending on the quality ordered.
 
You must log in or register to reply here.
Back
Top