Going to level my table this weekend... I have a question!

C

commodeair

Registered
Hey guys, I'm going all in, and attempting this saturday. I have a gold crown 3. My questions are, the bolt and screw, that screw into the frame, is the purpose of the bolt to move the table up and down with the slates on it? I would assume so. Where will that bolt lie on the threads? will it be down on the "foot" or will it be high against the frame. It seems like it will be hard to get at. Does this make sense? I'm going to follow Glen examples above, and He mentions adjusting the frame after the slate is on. Also I plan on stapling the simonis 860HR cloth to the frame. what glue do you use to line the pockets with excess cloth? I bought a starrett 8" level and I'm going to take my time. Any other advice from you guys would be appreciated. Thank you!!!!!
 
Are we installing in the garage or in the house? garage floor has a taper for water run off so you will need to adjust feet accordingly. If your table has the upgraded levelers from Brunswick in the frame then make them below flush so the slate has as much contact to the frame as possible then adjust levelers when needed.

The more prep work you do the better it comes out since its your first time.

Craig
 
You must log in or register to reply here.
Back
Top