Help needed identifying this shaft

W

wambamcam

AzB Silver Member
Silver Member
Okay, I've already had some input that it may be a Lomax, Bender, BCM, and Cog. Here are the two pics I can provide. Not sure of the joint thread, so maybe some of the experts could tell by the pic what thread size it is.

Any feedback is appreciated and thanks in advance.
 

Attachments

  • mystery.jpg
    mystery.jpg
    94.9 KB · Views: 277
  • mystery2.jpg
    mystery2.jpg
    97.1 KB · Views: 262
BCM shaft, 3/8-10 pin would be my guess. Bryan is a regular poster on the forums, so you might want to PM him about it. Could be a Lomax, too, but there aren't enough threads for a Bender...

Steve
 
Need ID on shaft

I agree...BCM!

Hunter said:
BCM shaft, 3/8-10 pin would be my guess. Bryan is a regular poster on the forums, so you might want to PM him about it. Could be a Lomax, too, but there aren't enough threads for a Bender...

Steve
Click to expand...
 
The ring looks like a Mike Bender.
It is NOT a 3/8-10 screw. If you hold something up to the photo and visualize where 5 threads are, then go to the ruler, you'll see it's a shade over 3/8 inches for 5 threads. This comes out to between 13 and 14 threads per inch. Bender uses 3/8-14 threads. My money is on Bender.

--JIM BUSS--
http://www.jimbuss.com
 
Jim Buss said:
The ring looks like a Mike Bender.
It is NOT a 3/8-10 screw. If you hold something up to the photo and visualize where 5 threads are, then go to the ruler, you'll see it's a shade over 3/8 inches for 5 threads. This comes out to between 13 and 14 threads per inch. Bender uses 3/8-14 threads. My money is on Bender.

--JIM BUSS--
http://www.jimbuss.com
Click to expand...


Great information Jim.

JIMO
 
Did get in touch with Bryan and he said it was not one of his. He also suggested that it may be a Bender as well. Anyone know if Mike has an account on AZ?
 
You must log in or register to reply here.
Back
Top