Help with weight bolt

[wdmortland]

What tool do I use to remove this type of weight bolt and are replacements available in plastic or aluminum ? This is a AE cue.Thanks in advance.

 

[akaminski]

Looks like what you need is something like this predator uni-loc weight bolt kit..... These were available with some of their p3 models

 

[Jim Baxter]

If that hole in the weight bolt is not threaded , Id go to NAPA and get a set of e z outs . I have a set I use quite often . jim

 

[wdmortland]

if I can find a replacement in plastic or aluminum I would do a ez out. The hole is threaded for the allen bolt for the bumper. The cue but is 16.5 and im trying to get it lighter. Thanks

 

[MVPCues]

As akaminsky suggested, the two round depressions are for a special "wrench". Some of the antique table bolt heads are like this. A good pair of needle nosed pliers will likely do the trick.

 

[Dirtbmw20]

Just use a good pair of snap ring pliers. Not the cheap set from Harbor Freight as the tips of them tend to bend, but a good set of Craftsman, SnapOn, Matco, etc.. snap ring pliers and they'll work just fine.

 

[VikingCueMfg]

Snap ring pliers should work... otherwise and adjustable spanner wrench is what I use.

 

[GBCues]

Snap ring pliers should work... otherwise and adjustable spanner wrench is what I use.

Did you notice the date of the post you replied to?
Gary