Not sure if a similar thread has already been posted but,
I currently have this Jacoby ultra pro in 5/16x18 with a brass insert I got a while back and I'd like to fit it with a radial butt. Is it possible to drill right into the brass insert and use a radial tap on it?
And if so would it be expensive to the point that I'm better of just getting a new cue?
Are there many risks of serious damage with such a procedure?
I'm also curious in the possibility of converting a mezz wavy shaft to radial.
I'd appreciate any form of of advice or help, thanks.
I currently have this Jacoby ultra pro in 5/16x18 with a brass insert I got a while back and I'd like to fit it with a radial butt. Is it possible to drill right into the brass insert and use a radial tap on it?
And if so would it be expensive to the point that I'm better of just getting a new cue?
Are there many risks of serious damage with such a procedure?
I'm also curious in the possibility of converting a mezz wavy shaft to radial.
I'd appreciate any form of of advice or help, thanks.