keep on trying

BHQ

BHQ

we'll miss you
Silver Member
in my effort to have two different lengths of the eliptical ovals,
i'm miscalculating somewhere that's causing the two ovals to not intersect at the exact centers of each other
:banghead::banghead::banghead::banghead::banghead::banghead:
dammit dammit dammit

back to the drawing board :rolleyes:

you can see the x's in the first pic
 

Attachments

  • 1.JPG
    1.JPG
    56.8 KB · Views: 400
  • 2.JPG
    2.JPG
    80 KB · Views: 413
  • 3.jpg
    3.jpg
    74.6 KB · Views: 412
  • 4.jpg
    4.jpg
    68.8 KB · Views: 387
Last edited:
Brent you just need to send it to me and I'll use it in a cue....jk.....lol......your getting good at that.....darn sight better than I am......:(
 
potential remedy

if the forearm is very oversized, which it appears to be, one potential solution would be to drill the center hole slightly off center, take a pass and see where the x's line up.

looks like the x's aren't that far off where re-centering the forearm and taking passes until even, you could still have a salvageable forearm, but of course this would mean re-centering the forearm, which, in it of itself, has its issues.

hate to see good wood/ideas go to scrap heap.
 
rheester said:
if the forearm is very oversized, which it appears to be, one potential solution would be to drill the center hole slightly off center, take a pass and see where the x's line up.

looks like the x's aren't that far off where re-centering the forearm and taking passes until even, you could still have a salvageable forearm, but of course this would mean re-centering the forearm, which, in it of itself, has its issues.

hate to see good wood/ideas go to scrap heap.
Click to expand...
it's a handle
recentering wont change anything in this case
it cant be corrected
recentering would only move the tips of the bflys one direction and make them not even
 
Last edited:
You must log in or register to reply here.
Back
Top