For those of you using metal engine lathes, I keep trying to
determine if a 36" between centers is enough?
I will not be using the lathe to cut shafts
it would be used to do joint work, tips etc, gundrilling and
shaft cleaning , can anyone tell me for sure that this is going
to be too small, and if so why ?
Thanks
Mark
determine if a 36" between centers is enough?
I will not be using the lathe to cut shafts
it would be used to do joint work, tips etc, gundrilling and
shaft cleaning , can anyone tell me for sure that this is going
to be too small, and if so why ?
Thanks
Mark